Werbung
SUMMARY
1.1.1 Pedalboard
"Pedal A" has two hold-to-run control operative positions. When it is pushed downwards it controls chuck motor clockwise rotary movement. When the pedal
is lifted upwards it operates the opposite movement.
The chuck assembly speed can be continuously adjusted up to the maximum speed through a progressive pressure on the pedal, only in clockwise
direction.
"Pedal B" (inflation with pressure gauge)
The inflation pedal has only one function: with a hold-to-run control, it supplies air at a controlled pressure (max 4.2 ± 0.2 bar / 60 ± 3 psi).
Do not change the set operating pressure value using the maximum pressure valves. the manufacturer shall not be responsible for injury or
damage arising from unauthorised changes.
"Pedal B" (inflation with tubeless tubeless inflation - applies to models with tubeless inflation system)
The inflation pedal has two functions. The supply of air at max. controlled pressure as in the previous version, and a second function of a jet of air from the
inflation nozzle to assist the beading in of the tyre.
Do not change the set operating pressure value using the maximum pressure valves. the manufacturer shall not be responsible for injury or
damage arising from unauthorised changes.
•
On models with lateral lifting device
"pedal C" has two hold-to-run control operative positions. Pulling the pedal downwards the lifting device starts its rise while, on the contrary, pulling the
pedal upwards the lifting device starts descending.
By releasing the pedal at any time, the lifting device stops in its current position.
Pedal B
1
Tyre inflation with pressure gauge
2
Tyre inflation with pressure gauge + inflation nozzle (applies to models with tubeless inflation system)
KENDO - KENDO.EVO
Fig. 7
7105-M019-00
EN_13
Werbung
