Stryker MX-PRO R3 Bedienungsanleitung Seite 25

L L o o a a d d i i n n g g a a c c o o t t i i n n t t o o a a v v e e h h i i c c l l e e w w i i t t h h a a n n a a n n t t l l e e r r s s t t y y l l e e c c o o t t f f a a s s t t e e n n e e r r
Always load an occupied cot with a minimum of two trained operators. Two operators must be present when a cot is
occupied. Operators must be able to lift the total weight of the patient, cot, and any items on the cot.
W W A A R R N N I I N N G G
• Always support the load of the patient, cot, and accessories after the weight is off of the ground.
• Always use two operators when a cot is occupied.
• Always follow proper hand placement on hand grips. Keep all hands clear of the red safety bar pivots when you load or
unload the cot or change cot height position.
The higher an operator must lift the cot, the more difficult it may be to hold the weight. The operator must be able to lift the
cot high enough for the cot legs to extend when the cot is unloaded. An operator may need help if they are too short or if the
patient is too heavy to lift when unloading the cot. If you are a shorter operator, you may need to raise your arms higher to
allow the cot legs to extend.
N N o o t t e e - - You can load an unoccupied cot into a vehicle with one operator.
To load the cot into a vehicle:
1. Place the cot in a loading position. A loading position is any position where the load wheels meet the vehicle floor height.
2. Lift the vehicle bumper, if equipped, to the raised position.
3. Roll the cot to the open door of the vehicle patient compartment.
4. Push the cot forward until the load wheels are on the vehicle patient compartment floor and the cot safety bar passes
the vehicle safety hook.
5. Pull the cot back until the cot safety bar connects to the vehicle safety hook for maximum clearance to lift the base.
6. Make sure that the cot safety bar connects with the vehicle safety hook.
7. Load the cot.
With one operator at the foot end and one operator on the
side
a. Operator 1 (at the foot end):
i. Grasp the cot frame at the foot end.
ii. Lift the foot end of the cot until you lift the weight
off of the latching mechanism.
Squeeze and hold the release handle.
b. Operator 2 (on the side):
i. Grasp the cot outer rail to stabilize the cot.
ii. Grasp the base frame.
iii. After the foot end operator lifts the cot and
squeezes the release handle, raise the
undercarriage until it stops in the uppermost
position and hold it there.
iv. The foot end operator should release the handle to
lock the base in the retracted position.
8. Push the cot into the vehicle patient compartment.
9. Make sure that the cot is secured in the cot fastener (not included).
6082-209-005 Rev AA.2
With one operator (when loading an unoccupied cot)
a. Grasp the cot frame at the foot end and squeeze and
hold the release handle.
b. Lower the foot end of the cot to the ground.
c. Lift the foot end of the cot until it is level with the
compartment floor.
d. Grasp the base of the cot with one hand and pull up
the base of the cot towards the litter, reducing the
space between the base and the litter.
21 EN