Holding Device; Electrical Installation; Electrical Installation With Circular Plug-In Connector; Safety Instructions - bürkert 3363 Schnellstartanleitung

The actuator cannot be turned on devices that have a
holding device fitted.
7.6

Holding device

→
Install holding device as shown in the image on the hexagon
head of the actuator.
NOTE!
Ensure that the actuator is rotated to the correct position
beforehand.
→
Fix the holding device in place by suitable means.
Fig. 17: Mounting the holding device
26
Holding device
english
Type 3363, 3364, 3365

Electrical installation

8 ELECTRICAL INSTALLATION
The electromotive diaphragm control valve is available in 2 con-
nection variants:
• With a circular plug-in connector (multi-pin variant)
• Cable gland with connection terminals
Signal values
Operating voltage: 24 V
Set-point value: 0 ...20 mA; 4...20 mA
0...5 V; 0...10 V
8.1 Electrical installation with circular
plug-in connector
8.1.1

Safety instructions

WARNING!
Risk of injury due to improper installation.
▶ Installation may be carried out by authorised technicians
only and with the appropriate tools.
▶ Observe general engineering standards & rules during
installation.
Risk of injury due to unintentional activation of the system
and uncontrolled restart.
▶ Secure the system against unintentional activation.
▶ Following installation, ensure a controlled restart.