F-Parameters - TR-Electronic CDH75M 8192/32768 EPN 20H7NT+FS-Serie Gesamt-Bedienungsanleitung

Parameter definition / CRC calculation

3.2 F-Parameters

Except for
meaningful values in the defaultsetting and should only be changed if expressly
requested by the automation function. For safe transmission of the individually set
F-Parameters
TIA Portal V13. This checksum corresponds to the F-Parameter F_Par_CRC,
which is displayed in the device view in the inspector window under Properties
-> General -> PROFIsafe during configuration of the measuring system. Also see
the chapter "Setting the F-Parameters" on page 110.
 TR-Electronic GmbH 2016, All Rights Reserved
Page 92 of 159
F_Dest_Add
the F-Parameters are already preconfigured with
a CRC is required,
TR-ECE-TI-DGB-0292 v02
which is calculated
Printed in the Federal Republic of Germany
automatically by
08/06/2021