Panasonic AW-PH360L Bedienungsanleitung Seite 39

Connections
=When the camera and pan/tilt head are to be controlled by a personal computer or other
such unit
Nominal cross section
2
1.25 mm
AC adapter:
AW-PS300A
• Use the supplied camera cable to connect the unit with the convertible camera.
• Set controller selection switch SW1 to the right side (RP501), and select the
transmission signal selection setting that supports the analogue/IEEE1394 card.
• Use the RS-232C cable (AW-CA28T9) to connect the personal computer or other such
unit with the unit's CONTROL IN RS-232C connector.
• Use coaxial cables to connect the unit's VIDEO OUT connector or Y OUT connector,
Pr/SDI OUT connector and Pb OUT connector with the colour monitor's VIDEO input
connector or component input connectors.
• Check that the pan/tilt head and camera can be controlled by the controller.
• Transmitting video signals over a long distance requires a separate cable
compensation unit.
When SDI signals are to be transmitted, plug the SDI card (such as the AW-PB504)
into the convertible camera, connect the SDI card's SDI OUT connector with the unit's
SDI IN connector using a coaxial cable, and select the transmission signal selection
setting that supports the SDI card. Then use another coaxial cable to connect the
unit's Pr/SDI OUT connector with the colour monitor's SDI input connector.
Camera cable
(supplied)
or more
Coaxial cable
RS-232C cable: AW-CA28T9
• The BNC connectors are not
connected to the pan/tilt head.
• When using RS-232C for
control, the maximum length
of the RS-232C cable is
15 meters. To further extend
the cable length, convert
RS-232C to RS-422 and
convert it back to RS-232C at
the pan/tilt head side.
- 38 (E) -
Colour monitor
Personal computer
(Windows)