Panasonic AW-PH360L Bedienungsanleitung Seite 28

Connections
2When the camera and pan/tilt head are to be controlled by the AW-RP501 control panel
for transmitting component signals
Nominal cross section
1.25 mm
AC adapter:
AW-PS300A
• Use the supplied camera cable to connect the unit with the convertible camera.
• Set controller selection switch SW1 to the right side (RP501), and select the
transmission signal selection setting that supports the analogue/IEEE1394 card.
• Use a 10BASE-T straight cable (UTP category 5) to connect the unit's CONTROL IN
IP/RP connector with the controller's PAN TILT CONTROL OUT connector.
• Use a coaxial cable (BBC No.PSF1/2M, BELDEN 8281) to connect the unit's CAMERA
CONTROL IN connector with the controller's CAMERA CONTROL OUT connector.
• Use coaxial cables to connect the unit's Y OUT connector, Pr/SDI OUT connector and
Pb OUT connector with the component input connectors on the colour monitor.
• Check that the pan/tilt head and camera can be controlled by the controller.
• Transmitting component signals over a long distance requires a separate cable
compensation unit.
Camera cable
(supplied)
2
or more
10BASE-T
(equivalent to UTP
category 5) straight
cable (max. 500 m)
Coaxial cable
Coaxial cable (BBC No.PSF1/2M,
BELDEN 8281, max. 500 m)
- 27 (E) -
Colour monitor
Hybrid control panel:
AW-RP501