Replace The Dust Filter; Changing Fuses - Kärcher KM 100/100 R LPG Betriebsanleitung

Operating Instructions
! Unscrew fastening nuts of the
rear sealing strip
! Screw on new sealing strip
Side sealing strips
! Slightly loosen fastening nuts of
the side sealing strip, unscrew
them to replace it
! Screw on new sealing strip but
do not yet tighten nuts
! In order to set the clearance to
the floor slide in the 1 - 2 mm
spacer
! Align the sealing strip
! Tighten nuts
! Screw on side panelling
! Insert the swept material
container
KM 100/100 R B / KM 100/100 R LPG

Replace the dust filter

Danger!
! Empty the debris container prior
to beginning work on replacing
the dust filter
! Wear a dust protection mask
when working on the filter system
! Observe the safety precautions
for handling fine dust
! Open unit cover, engage stay bar
! Pull out handle of filter bracket to
limit and engage it
! Take out finned filter
! Insert the new filter
! On the drive side, engage the
carrier into the holes
! Re-engage the handle of filter
dedusting
Note:
Make sure when mounting the new
filter that the lamella are not
damaged
Replacing the filter box
seal
Remove filter box seal from the
groove in the unit cover and insert
the new seal
Checking traction belt
Danger!
The engine takes approx. 3...4 s to
run down after being shut off.
Never enter operating area during
this period!
! Turn ignition key to "0" and
remove it
! Open unit cover, engage stay bar
Check round belts and V-belts for
tightness, wear and damage

Changing fuses

The drive control electronics are
beneath the front covering.
The front covering must be removed
when a fuse needs replacing.
English
! Unscrew the screws at both sides
of the covering
Note:
— See interior for fuse allocation
— Use only fuses with the same
current rating
! Replacing blown fuses
! Refasten front covering
40