Checking/Replacing The; Clean And Change Spark Plug; Check And Top Up The; Hydraulic Oil Level - Kärcher KM 100/100 R LPG Betriebsanleitung

Operating Instructions
Checking/replacing the air
cleaner
! Open unit cover, engage stay bar
! Unscrew wing nut
! Remove, check and clean filter
insert
! Insert clean or new filter insert
into the suction container.
! Tighten the wing nut
KM 100/100 R B / KM 100/100 R LPG
Clean and change spark
plug
! Open unit cover, engage stay bar
! Remove the spark plug
connector
! Screw the spark plug out and
clean it
! Screw the cleaned or the new
spark plug in
! Plug in the spark plug connector.

Check and top up the

hydraulic oil level

Note:
The sweeper is provided with two
hydraulic circuits:
1. Sweeping hydraulics circuit
! Check of fill level in the storage
reservoir
! Open unit cover, engage stay bar
The oil level must be between the
"MIN" and "MAX" marks.
! Open the cap to refill
! Fill in hydraulic oil
! Close reservoir
For oil grade see: Technical data
2. Axle drive circuit
! Check of fill level in
compensating reservoir
Note!
This check may be performed only
when the engine is cold.
! Open unit cover, engage stay bar
! Remove the reservoir cap
— In the reservoir its bottom may
just be covered with oil
! If necessary, carefully replenish
with oil
! Close reservoir
For oil grade see: Technical data
English
Checking the vacuum
system
— Adding a sweeping system is
with the aid of a vacuum system.
— The vacuum canister for lowering
the side brush is to be checked
for leaks and proper connection
of the hose if the side brush
cannot be lowered; attach the
hose, if necessary.
Hose connection to vacuum canister
of side brush lowering
— The vacuum system is leaking if
the side brush can still not be
lowered. In this case after-sales
service must be contacted.
37