Herunterladen Diese Seite drucken

Sony SQD-2020 Bedienungsanleitung Seite 34

Werbung

34
Note:
"When
reproducing
discrete
four-channel
or
conven-
tional two-channel
sounds
the VU meters may go into
the red zone
This +s because
the program
does
not
pass
the Input LEVEL ADJUST
controt when you select
the DISCRETE.
4 CH TAPE or
2CH_
Therefore, adjust
the output
level controls
of the tape
recorder
connected
so that the meters
read around O VU
ff the recorder
has no output
leve!
controls.
adjust
the
signa!
level
with the SQD-2020's FRONT and BACK LEVEL controls.
When you select SQ, R-MTX, or 2—4, after readjusting
the FRONT and BACK LEVEL controls, be sure to return
them
to their standard
setting (as determined
in "Ill.
Four channel Balance Adjustments" on page 26.}
OTo play discrete four-channe! records, a special cartridge
and an
adaptor
must
be
added.
If you
have
these
components,
connect
the outputs of the discrete four-
channel adaptor to the SQD-2020's DISCRETE INPUTs.
Tape Recording
Two-channel
tape recording:
While reproducing phono, fm or
auxiliary program
sources,
the signal fed to the FRONT PREAMP
INPUT jacks always goes directly to the 2 CH TAPE RECORI
REC OUT jacks and the REC/PB connector without being decoded.
Therefore,
any SQ program can be recorded as an SO tape.
The
input LEVEL ADJUST contro! has no effect on the recording re-
sults in these circumstances.
Four-channel tape recording :
The signals fed to the 2 CH TAPE RECORDER TAPE input jacks
and the FRONT
PREAMP
INPUT
jacks
go to the
4 CH
TAPE
RECORDER
REC OUT jacks after passing through the decoder
circuit.
Therefore, you can record an SO program,
another
type
matrix
program,
or a conventional
two-channel
program
as
four-channel sound.
When
recording, push either the SQ, R-MTX
or 24
button.
The signals fed to the DISCRETE
INPUT jacks are directly fed
to the 4 CH TAPE RECORDER
REC OUT jacks.
CLEANING
Finger prints, the children's chocolate candy, and similar house-
hold annoyances
can
mar the beauty of your SQD-2020.
These
can
be cleaned
up by wiping the panel or knobs with a soft clean
cloth moistened with water.
Do not use any type of scouring
powder, abrasive pads, or solvents.

Werbung

loading