TAPE THREADING
RECORDING
Set the REEL SIZE selector according to the reels to be used.
Fundamental steps
Use the same size reels for both supply and take-up.
~ Check the INPUT SELECT switch:
1. Secure the reels.
When recording from LINE IN jacks — LINE
When recording from REC/PB connector — REC/PB
O
2. Pass the tape.
3. Wrap the tape around the hub of the right reel or insert the end
of the tape into the reel slot.
4. Rotate the reels a few times by hand
until there is no Secx in
the tape.
If there is slack, tape will not move even if the function
button is depressed.
QOQOOOO0O
=|
eled
OOOH
oO
@ TIMER switch + OFF
@ POWER switch > Depress to ON.
© Thread a tape.
@ Tape counter —> Reset to [0000]
@ REEL SIZE selector — Set to the reel diameter to be used.
@ TAPE SPEED selector — As desired.
inOOO0O
SasoaS
<I
<
TAQ
a
For the supplied 27 cm (10 1/2-inch) metal reel, use the supplied
reel adaptor RAD-11 (reel holder and spacer) as illustrated.
Ci —~
Reel
holder
@For optional
plastic reel, neither
reel holder
nor spacer
is re-
quired,
If the plastic reel has a large center
hole, use the reel
holder only.
The spacer is unnecessary.