Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• The oven must cool down before clean-
ing the cooking area. Cleaning on hot
surfaces shall create both fire hazard
and damage the enamel surface.
Catalytic surfaces
• The side walls in the cooking area can
only be covered with enamel or catalytic
walls. It varies by model.
• The catalytic walls have a light matte
and porous surface. The catalytic walls
of the oven should not be cleaned.
• Catalytic surfaces absorb oil thanks to
its porous structure and start to shine
when the surface is saturated with oil, in
this case it is recommended to replace
the parts.
Glass surfaces
• When cleaning glass surfaces, do not
use hard metal scrapers and abrasive
cleaning materials. They can damage the
glass surface.
• Clean the appliance using dishwashing
detergent, warm water and a microfiber
cloth specific for glass surfaces and dry
it with a dry microfiber cloth.
• If there is residual detergent after clean-
ing, wipe it with cold water and dry with
a clean and dry microfiber cloth. Resid-
ual detergent may damage the glass
surface next time.
• Under no circumstances should the
dried-up residue on the glass surface be
cleaned off with serrated knives, wire
wool or similar scratching tools.
• You can remove the calcium stains (yel-
low stains) on the glass surface with the
commercially available descaling agent,
with a descaling agent such as vinegar
or lemon juice.
• If the surface is heavily soiled, apply the
cleaning agent on the stain with a
sponge and wait a long time for it to
work properly. Then clean the glass sur-
face with a wet cloth.
• Discolorations and stains on the glass
surface are normal and not defects.
Plastic parts and painted surfaces
• Clean plastic parts and painted surfaces
using dishwashing detergent, warm wa-
ter and a soft cloth or sponge and dry
them with a dry cloth.
• Do not use hard metal scrapers and ab-
rasive cleaners. They may damage the
surfaces.
• Ensure that the joints of the components
of the product are not left damp and with
detergent. Otherwise, corrosion may oc-
cur on these joints.
7.2 Cleaning Accessories
Do not put the product accessories in a
dishwasher unless otherwise stated in the
user's manual.
7.3 Cleaning the Control Panel
• When cleaning the panels with knob-
control, wipe the panel and knobs with a
damp soft cloth and dry with a dry cloth.
Do not remove the knobs and gaskets
underneath to clean the panel. The con-
trol panel and knobs may be damaged.
• While cleaning the inox panels with knob
control, do not use inox cleaning agents
around the knob. The indicators around
the knob can be erased.
• Clean the touch control panels with a
damp soft cloth and dry with a dry cloth.
If your product has a key lock feature, set
the key lock before performing control
panel cleaning. Otherwise, incorrect de-
tection may occur on the keys.
7.4 Cleaning the inside of the oven
(cooking area)
Follow the cleaning steps described in the
"General Cleaning Information" section ac-
cording to the surface types in your oven.
Cleaning the side walls of the oven
The side walls in the cooking area can only
be covered with enamel or catalytic walls.
It varies by model. If there is a catalytic
wall, refer to the "Catalytic surfaces" sec-
tion for information.
EN / 34
EN
DE
Werbung
