HBM ClipX Bedienungsanleitung Seite 81

6. For Subnet mask enter the same groups of numbers as are present on the
HBM device.
7. Then click OK or Close to close all open dialogs.
See also "Example" on page
Procedure for Windows 7
1. From the Windows Start menu select Control panel → Network and shar-
ing center(display: Small icons) or Show network status and tasks
(View by: Categories).
2. Click in the Show active networks area on the connection you want (usu-
ally LAN connection).
3. Click on Properties and specify an administrator account or confirm the
confirmation prompt.
4. Select Internet protocol version 4 (TCP/IPv4) and click on Properties.
5. Activate Use the following IP address and enter an address with which the
first three groups of numbers match the groups of numbers of the HBM
device and only the last group of numbers contains a different number
between 1 and 254. The last group of numbers must not match the one on
the HBM device.
6. For subnet mask enter the same digit groups as those available on the
HBM device.
7. Then click OK or Close to close all open dialogs.
See also "Example" on page
Procedure for Windows XP
1. From the Windows Start menu select Settings → Network Connections.
From the context menu (right-click), choose the Properties of the relevant
LAN connection.
2. Select Internet protocol (TCP/IP) and click on Properties.
3. Activate Use the following IP address and enter an address with which the
first three groups of numbers match the groups of numbers of the HBM
device and only the last group of numbers contains a different number
ClipX
80.
80.
A04643_04_X00_03 HBM: public
Starting up the ClipX
79