Name
Format
Fieldbus
FLOAT
value 1
Fieldbus
value 2
Limit value 1
FLOAT
Limit value 2
Limit value 3
Limit value 4
Fieldbus
UINT
flags
Control word
UDINT
Parameter
UINT
set number
ClipX
Cycle in
Function
ms
1
The ClipX uses these values like measure-
ment values, for example in calculated chan-
nels or for the limit switches.
You can assign these values physical units for
display in your browser.
The values have no status information, and so
are always classed by ClipX as valid.
1
Threshold values of the limit switches.
The ClipX reacts to changes, then the values
are applied. They are also applied when any
other value in the data changes from the con-
troller to the ClipX.
1
16 control flags that can be used universally in
the ClipX like internal flags, such as to reset
peak values.
These flags are transferred in the digital flags
into bits 32 ... 47.
See also
status)" on page
ClipX to the controller" on page
1
32 control flags with fixed assigned functions.
See
"The control word" on page
1
Parameter set number 1 ... 10.
Switches the ClipX to the parameter set with
this number. The ClipX only reacts to a
change in this value.
If you want to reactivate the original (same)
parameter set after changing settings, you
must first change the value. You can also
specify a non-existent parameter set number
when doing so.
A04643_04_X00_03 HBM: public
Operation via fieldbus
"Digital flags: List of I/O flags (I/O
162,
"Data transfer from the
129.
163.
127