Adaptation Of Device To Flux-Cored Welding Wire Without Inert Gas; Inserting The Flux-Cored Wire - Parkside PSGS 120 A1 Bedienungs- Und Sicherheitshinweise

Welding with flux-cored wire
with the "-" (see Figure U) and rotate
in a clockwise direction to fix it in
place.
V
The gas flow can now be adjusted
„
using the pressure regulator
Figure V). Rotating the regulator on
the pressure regulator in a clockwise
direction will increase the gas flow.
If you would like to use inert gas
from an external source (e.g. 20 l
gas cylinder), then you will need
a separate pressure regulator (not
included with the delivery). Connect
the external inert gas source with the
insert gas inlet tubing
ing device. To do this an adapter
may be required (not included with
delivery). Also observe the notes for
your separate pressure regulator. You
can use the following formula as a
guideline for adjusting the gas flow:
Flux-cored wire diameter in mm x 10
= gas flow in l/min
For example, using 0.8 mm wire,
will give a value of approx. 8 l/min.
48 GB/IE
z Adaptation of device to
If you are using solid wire with
integrated inert gas, then you do not
12
have to have an external inert gas
supply.
„
13
„
14
z Inserting the flux-cored
(see
14
„
„
of the weld-
13 „
Note:
wire does not come loose and cause the
roll to roll out on its own. The end of the
wire may not be released until during
assembly.
„
„
flux-cored welding wire
without inert gas
First connect the plug
nector marked with the "-" and rotate
it in a clockwise direction to fix it in
place. If you are in any doubt, then
please contact a professional.
Then connect the earth cable
with the corresponding connector,
marked with the "+" and rotate
in a clockwise direction to fix it in
place.
wire
Unlock and open the cover of
the wire feed unit
the release knobs
39
(see Figure T).
Unlock the roller unit by turning
the roller mount
34
(see Figure G).
Pull the roller mount
(see Figure G).
Make sure that the end of the
Completely unpack the flux-cored
wire welding spool
unrolled without difficulty. Do not
release the wire end yet.
Place the wire reel on the shaft.
Make sure that the roll unwinds on
the side of the wire feed guide
35
(see Figures H, N).
with the con-
9
6
, by pushing
1
upwards
clockwise
off the shaft
34
, so that it can
17