Parkside PSGS 120 A1 Bedienungs- Und Sicherheitshinweise Seite 58

Place the roll mount
„
lock it by pressing and turning it
anti-clockwise (see Figure H).
Undo the adjustment screw
„
swing it forwards (see Figure I).
Turn the thrust roller unit
„
side (see Figure J).
Loosen the feed roll holder
„
turning it anti-clockwise and pull it
forwards and off (see Figure K).
On the top of the feed roll
„
check whether the appropriate wire
thickness is indicated. If necessary,
the feed roll has to be turned over or
replaced. The supplied welding wire
(Ø 0.8 mm) must be used in the feed
roll with the specified wire thick-
19
ness of Ø 0.8 mm. The wire must be
positioned in the front groove!
Erect the feed roll holder
„
and screw clockwise direction.
Make sure that the feed roll holder is
properly aligned (see Figures I, J).
Remove the torch nozzle
„
pulling and turning it anti-clockwise
(see Figure L).
Unscrew the welding nozzle
„
(see Figure L).
Guide the torch
„
the welding device as straight as
possible (place it on the floor).
Take the wire end out of the edge of
„
the spool (see Figure M).
Trim the wire end with wire scissors
„
or a diagonal cutter in order to
remove the damaged, bent ends of
the wire (see Figure M).
The wire must be kept under ten-
Note:
sion the entire time in order to avoid
a releasing and a roll out! Therefore it
is recommended to carry out the work
with an additional person.
Push the flux-cored wire through the
„
wire feed guide
Guide the wire along the feed roll
„
and then push it into the flux-cored
wire holder
36
back on and
34
and
31
to the
32
by
33
,
19
again
33
by
37
16
away from
7
(see Figure N).
35
(see Figure O).
Welding with flux-cored wire
Swivel the thrust roller unit
„
the feed roll
Mount the adjustment
„
(see Figure P).
Set the counter pressure with the
„
adjustment screw
wire must be firmly positioned
between the thrust roller and feed roll
in the front groove without being
19
crushed (see Figure P).
Switch on the welding device on the
„
main switch (see Figure A).
12
Press the torch button
„
Now the wire feed system pushes
„
the welding wire through the cable
assembly and the torch
As soon as 1 – 2 cm of the wire
„
protrudes from the torch neck
release the torch
(see Figure Q).
Switch off the welding device on the
„
main switch.
Screw the welding nozzle
„
on. Make sure that the welding
nozzle
16
the welding wire used (see Figure R).
When using the delivered welding
wire (Ø 0.8 mm), the welding nozzle
with the
16
used.
Push the torch nozzle
„
on to the torch neck by turning it
anti-clockwise at the same time
(see Figure S).
plug from the socket prior to each
maintenance task or preparatory work
in order to prevent the risk of an electric
shock, injury or damage.
19
32
(see Figure P).
19
screw
31
. The welding
31
.
8
.
7
button again
8
16
matches the diameter of
labelling 0.8 mm must be
back
37
Always unplug the mains
GB/IE
towards
,
38
back
38
49