Adaptation Of Device To Solid Welding Wire With Inert Gas; Adaptation Of Device To Flux-Cored Welding Wire Without Inert Gas - Parkside PMSG 200 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

z Adaptation of device to
solid welding wire with
inert gas
The correct connections for solid wire
welding when using inert gas are shown
in Fig. S. When using the aluminium
solid wire delivered with the product,
then you must use argon as the inert gas
(not included with the delivery).
S
35
32
38
10
First connect the plug
„
connector marked with the "+"
(see Fig. S). To fix it in place, rotate
in a clockwise direction. If you are
in any doubt, then please contact a
professional.
Now connect the cable assembly
„
with direct connection
appropriate connector (see Fig. S).
Fix the connection in place by
tightening the fixing ring
clockwise direction.
Then connect the earth cable
„
with the corresponding connector,
marked with the "-" (see Fig. S).
To fix the connection in place, rotate
in a clockwise direction.
36
„
6
„
4
with the
32
Wire diameter in mm x 10 =
gas flow in l/min
to the For example, using 0.8 mm wire, will
10
give a value of approx. 8 l/min.
in a
38
z Adaptation of device to
4
If you are using solid wire with inte-
grated inert gas, then you do not have
to have an external inert gas supply.
„
T
Pull the protective cap off the
compressed air connection
Now connect the inert gas feed
including the pressure reducer
(not included with the delivery) to
the compressed air connection
(see Fig. T). Inert gas is required if
you are not using flux-cored wire
with integrated solid inert gas. If
necessary, observe the notes for
your pressure reducer (not included
with the delivery). You can use the
following formula as a guideline for
adjusting the gas flow:
flux-cored welding wire
without inert gas.
First connect the plug
connector marked with the "-".
MIG welding
5
33
.
33
33
with the
32
GB 19