Stryker Power-PRO TL Cot Handbuch Seite 37

1 2 3 4
F F i i g g u u r r e e 2 2 5 5 – – A A n n k k l l e e r r e e s s t t r r a a i i n n t t s s
S S e e c c u u r r i i n n g g t t h h e e p p a a t t i i e e n n t t w w i i t t h h t t h h e e P P e e d d i i - - M M a a t t e e ® ® i i n n f f a a n n t t r r e e s s t t r r a a i i n n t t s s y y s s t t e e m m
W W A A R R N N I I N N G G - - Always locate the buckle away from obstructions or accessories on the cot to avoid the risk of accidental
release of P P e e d d i i - - M M a a t t e e ® infant restraint system and injury to the infant.
To secure the patient with the P P e e d d i i - - M M a a t t e e ® infant restraint system:
1. Remove any restraints from the cot.
2. Raise the cot backrest to the full upright position.
3. Position the P P e e d d i i - - M M a a t t e e ® pad flat on the cot backrest with the black backrest straps facing out.
4. Wrap the straps around the cot backrest and insert the ends of the straps through the brackets.
5. Fasten the buckle.
6. Pull on the end of the adjustable backrest strap to tighten.
7. Insert the mainframe straps between the product frame and the mattress.
8. Insert the buckle behind the litter cross brace and bring it up in front of the litter cross brace.
9. Fasten the buckle around the litter cross brace. Leave slack in the strap for final adjustment.
10. Tighten all straps.
N N o o t t e e - - For more information about the P P e e d d i i - - M M a a t t e e ® infant restraint system, see the manufacturer's instructions for use,
operation, and care. Safe and proper use of the P P e e d d i i - - M M a a t t e e ® infant restraint system is at the discretion of the user. Set
methods and procedures to educate and train your staff on the safe operation or maintenance of this product. These are
general instructions only. Keep these instructions for future reference. These instructions are a permanent part of the
product and should remain with the product even if the product is sold.
P P e e d d i i - - M M a a t t e e ® is a registered trademark of Ferno Washington, Inc.
I I n n s s t t a a l l l l i i n n g g t t h h e e d d e e f f i i b b r r i i l l l l a a t t o o r r p p l l a a t t f f o o r r m m
C C A A U U T T I I O O N N
• Always secure the defibrillator platform to the product when you use the defibrillator platform.
• Always use and adjust the straps that are provided with the defibrillator platform to secure the defibrillator.
• Always change the installation location or adjust the straps for your specific defibrillator size or shape.
• Do not load the defibrillator platform above the safe working load of 30 lb (13.6 kg).
To install the defibrillator platform:
1. Place the defibrillator platform in the stored position (Figure 26).
2. Open and expand the defibrillator platform legs (Figure 27).
6550-309-005 Rev H.0 33 EN