Stryker Power-PRO TL Cot Handbuch Seite 32

A
F F i i g g u u r r e e 1 1 7 7 – – R R e e t t r r a a c c t t t t h h e e h h e e a a d d s s e e c c t t i i o o n n o o r r f f o o o o t t s s e e c c t t i i o o n n
R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e o o p p t t i i o o n n a a l l k k n n e e e e G G a a t t c c h h
To raise the optional knee Gatch:
1. Lift either of the red lifting loops (A) until the knee Gatch is in the highest position (Figure 18).
2. Lower the knee Gatch to secure the support bracket to the locking mechanism.
3. Make sure that the locking mechanism is secure before you release the lifting loop.
To lower the knee Gatch, lift either of the red lifting loops (A) to relieve pressure on the locking mechanism, and while
holding the loop, push on the red footrest release handle (B) until the support bracket is released. Lower the knee Gatch
until it lays flat.
To raise the knee Gatch in trend, lift the footrest frame (C) as high as possible until the frame locks into place. The support
bracket automatically connects when you release the frame.
To lower the knee Gatch in trend, lift the footrest frame (C), and while holding the frame, lift up on the red footrest release
handle (B) until the frame releases the support bracket. Lower the footrest until it lays flat.
N N o o t t e e - - The optional foot end oxygen bottle holder (6500-240-000) is not compatible with the optional knee Gatch (6500-
082-000).
EN 28 6550-309-005 Rev H.0