Stryker Power-PRO TL Cot Handbuch Seite 31

R R e e t t r r a a c c t t i i n n g g t t h h e e r r e e t t r r a a c c t t a a b b l l e e h h e e a a d d s s e e c c t t i i o o n n o o r r f f o o o o t t s s e e c c t t i i o o n n
The head section telescopes from an extended position to a retracted position within the litter frame.
W W A A R R N N I I N N G G
• Always lock the head section into place before you operate the cot.
• Do not attempt to load the cot into the vehicle patient compartment with the head section retracted. Loading the cot with
the head section retracted may cause the product to tip or not connect to the vehicle cot fastener.
To retract the head section or foot section:
1. Squeeze the red release levers (A) on each side of the frame as you push the head or foot section out of its extended
position (Figure 17).
2. Make sure that the head section or foot section locks into position.
6550-309-005 Rev H.0
F F i i g g u u r r e e 1 1 6 6 – – E E x x t t e e n n d d t t h h e e h h e e a a d d s s e e c c t t i i o o n n o o r r f f o o o o t t s s e e c c t t i i o o n n
A
27 EN