Robacta W / V Testing System - Testing Water-Cooled, Customer-Specific Robot Welding Torches; Preparing The Testing System - Fronius Robacta series Bedienungsanleitung

Robacta W / V Testing System - Testing Water-
Cooled, Customer-Specific Robot Welding Torches
General With the Robacta W / V testing system, you can test water-cooled, customer-specific robot
welding torches and special models for dimensional deviations.
The user is responsible for the setup and initial adjustment.
Preparing the
Testing System
Assembly positions on the base plate
Mounting the testing unit
86
The base plate of the Robacta W / V testing
system contains 6 possible positions for
mounting the testing unit.
For packaging reasons, the testing unit is
pre-mounted the wrong way round on the
0° mounting position when delivered.
Mount the testing unit in the correct position
on the base plate for the torch neck curva-
ture of the welding torch to be tested:
Remove the Allen screw on the testing
1
unit using an Allen key (6 mm)
Remove the testing unit
2
Screw the testing unit to the correct po-
3
sition on the base plate for the torch
neck that is to be tested