RAVAGLIOLI RAV307H.4WS-VARSC Übersetzung Der Originalanleitung Seite 54

3) Return to the first column, the MASTER and the display will show:
> > C H 2 C O L
C o n f. C o p l ?
The operator must accept that the number of columns is equal to the total number of configured columns (including the Master).
If this condition is satisfied, then it is possible to close the configuration:
C H 2 C O L
> > C o n f. C o m p l ? < <
In case the number of columns shown on the display of the MASTER column is different from the columns that you want to confi-
gure, you must repeat the entire setup process from start by turning off and on all the columns.
If the number of the configured columns is different from (2-4-6-8), the Master column shall show the following error message:
W R O N G C O L U M N S
N U M B E R R E T R Y?
If the configuration is successful, the display will show:
H e i g h t 0 0 0 0
G R O U N D
B) Old configuration
Selecting this option allows you to restart with the same configuration as the previous shutdown: same Radio channel number (ID),
same columns (CH) and same heights and any quota offset from previous single or group operations.
1) When starting the switchboard, the following shall appear:
> > O L D C O N F I G
N E W C o n f i g
1A) Caution: In the event that a previous valid configuration is not stored, the display will show:
> > O L D C O N F I G
N O T S T O R E D
2) N.B: Repeat the operation described in paragraph 1 on all the columns in the selected configuration.
After selecting this option, the MASTER column checks if the previously used radio channel is still available and if there is com-
munication with all of the columns, in which case the display will show:
O L D C O N F I G
M S T C H 2
O L D C O N F I G
S L A V E C H 2
If the previously used radio channel is busy, the column automatically searches for a new radio channel to use. The display shows
the following message:
F R E E C H A N N E L
> > 3 S E L E C T
system (3 in our example) before confirming the selection with the black "ENTER" key on each column. If this does not happen, or
the operator wants to operate the power lift on a different channel than the one specified by the system, the operator must choose
a new channel by using the RED and GREEN keys on all columns that form the power lift and confirm the selection by pressing
the black"ENTER" key.
54
4 < <
(radio channel CH 2) (COL 2 - are the columns that form the power lift (2-4-6-8))
move down with the blue Key
4
confirm with the black "ENTER" key
mm
A L L
< <
confirm with the black "ENTER" key
< <
after this message the system automatically returns to the initial screen.
I D 1
C O L 2
MASTER column (ID 1 is always the master column)
I D 2
SLAVE column (ID2 to ID8 are the SLAVE columns)
? < <
The operator must ensure that all columns have the same radio channel indicated by the
, to
0526M002-2
7