Installing The Airborne™ Stackable - Stryker Power-PRO IT 6510 Bedienungs- Und Wartungshandbuch

INSTAllING THE AIRBORNE™ STACKABlE
Prior to installing the Airborne™ Stackable on the model 6510 Power-PRO™ IT cot, read and understand this manual
and the manual supplied with the incubator.
WARNING
The Airborne™ Stackable adaptor (6510-027-000) adaptor is designed to secure only an Airborne Stackable to the model
6510 Power-PRO™ IT cot. Using this adaptor on any cot other than the model 6510 or using any unapproved incubators
or stackables on this adaptor may result in damage to the cot and/or injury to the patient or user.
To install the adaptor:
1. Using the 1/2" socket and ratchet, remove the four 5/16" hex nuts and washers (A) from the mounting studs (B)
on the adaptor as shown in Figure 30.
2. Locate the mounting holes in the bottom of the oxygen bottle module (C).
3. Install the oxygen bottle holder on the adaptor mounting studs (B) with the bottle openings facing toward the
retractable head section. Verify that all four mounting studs are properly seated into the mounting holes of the
oxygen bottle holder.
4. Using a 1/2" socket and ratchet, install the four 5/16" hex nuts and washers (A) that were removed in step one
and securely tighten them.
C
C
WARNING
Verify that the adaptor is properly installed on the cot and the oxygen module is securely fastened to the adaptor prior
to use. An improperly attached adaptor or oxygen module may cause injury to the patient or user.
www.stryker.com
Cot Operation
A
A
B
B
Figure 30: Airborne™ Stackable
6510-009-005 REV A
A
A
B
B
HEAD END
Return To Table of Contents
English
1-53