Werbung
INSP
ADJ
CONTROL SYSTEM
WARNING
The
steering
screwed in at least 8 mm (0.31 in).
Connect the steering cable joint and
tighten the locknut.
Locknut:
6 Nm (0.6 m • kg, 4.3 ft • lb)
NOTE:
If the steering cable cannot be properly
adjusted at the steering column side, make
sure the steering cable at the jet pump side
is set to the specified length. Refer to
"REMOTE CONTROL CABLES AND SPEED
SENSOR LEAD" in chapter 8.
Throttle cable inspection and adjustment
NOTE:
Before adjusting the throttle lever free play,
adjust the trolling speed.
1. Measure:
Throttle lever free play a
Out of specification → Adjust.
Throttle lever free play:
4 ~ 7 mm (0.16 ~ 0.28 in)
2. Adjust:
Throttle lever free play
Adjustment steps:
Loosen the locknut 1.
Turn the adjusting nut 2 in or out until
the specified free play is obtained.
Turn in
Turn out
Tighten the locknut.
3-3
cable
joint
must
Free play is increased.
Free play is decreased.
E
be
Werbung
Kapitel
