Safety System; Starting Engine - Stiga PARK PRO 20 Gebrauchsanweisung

SAFETY SYSTEM

This machine is equipped with a safety system that
consists of:
- a switch on the gearbox (only Senator).
- a switch at the brake pedal.
- a switch in the seat (Senator, President) or the
seat bracket (other models).
- a switch at the power take-off engagement le-
ver.
In order to start the machine, the following are nec-
essary:
- gear lever in neutral (only Senator).
- brake pedal pressed down.
- driver sitting on seat.
- power take-off engagement lever in forward po-
sition (i.e. power take-off disengaged).
Always check the operation of the safe-
ty system before using the machine!
With the engine running and the driver sitting on
the seat, check as follows:
- select a gear, lift your weight off the seat – the
engine must stop (applies to Senator).
- press the drive pedal so that the machine starts
to move, release the drive pedal – the machine
must stop (applies to President, Royal, Pro16,
Pro20).
- press the drive pedal so that the machine starts
to move, engage the cruise control, lift your
weight off the seat – the machine must stop (ap-
plies to Royal, Pro16, Pro20).
- press the drive pedal so that the machine starts
to move, engage the cruise control, press the
brake pedal – the machine must stop (applies to
Royal, Pro16, Pro20).
- engage the power take-off, lift your weight off
the seat – the engine must stop (applies to Sen-
ator, President, Royal, Pro16).
- engage the power take-off, lift your weight off
the seat – the power take-off must be disen-
gaged (applies to Pro20).
Do not use the machine if the safety sys-
tem is not working! Take the machine
to a service workshop for inspection!

STARTING ENGINE

1. Open the fuel cock (fig. 16).
2. Make sure that the spark plug cable is properly
in place.
ENGLISH
3. Check to make sure that the power take-off is
disengaged.
4a. Senator:
Put the gear lever in neutral.
4b. President-Royal-Pro16-Pro20:
Do not keep your foot on the drive pedal.
5a. Senator-President:
Starting cold engine – put the throttle control in the
choke position. Starting warm engine – put the
throttle control at full throttle (approx. 1 cm behind
the choke position).
5b. Royal-Pro16-Pro20:
Put the throttle control at full throttle. Starting cold
engine – pull the choke control out fully. Starting
warm engine – do not touch the choke control.
6. Depress the brake pedal fully.
7. Turn the ignition key and start the engine.
8a. Senator-President:
Once the engine has started, move the throttle con-
trol gradually to full throttle if the choke has been
used.
8b. Royal-Pro16-Pro20:
Once the engine has started, push the choke control
in gradually if it has been used.
9. When starting from cold, do not make the ma-
chine work under load immediately, but let the en-
gine run for a few minutes first. This will allow the
oil to warm up.
When in use, always operate the engine at full
throttle.
STOPPING
Disengage the power take-off. Apply the parking
brake.
Allow the engine to idle 1 - 2 mins. Stop the engine
by turning off the starter key.
Shut off the petrol cock. This is particularly impor-
tant if the machine is to be transported on a trailer
for example.
If the machine is left unattended, re-
move the spark plug cable from the
spark plug. Also remove the starter key.
The engine may be very warm immedi-
ately after it is shut off. Do not touch the
silencer, cylinder or cooling fins. This
can cause burn injuries.
GB
61