Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch Seite 143

VORSICHT: Heben Sie die Systemplatinenbaugruppe nicht an einem Speichermodul, einem Prozessor oder anderen
Komponenten an.
VORSICHT: Take care not to damage the system identification button while placing the system board into the
chassis.
2. Holding the system board holder, push the system board toward the back of the system till it is seated.
VORSICHT: To prevent damage to the processor socket when replacing a faulty system board, ensure that you cover
the processor socket with the processor dust cover.
3. Using Phillips #2 screwdriver, tighten the screws to secure the system board to the chassis.
Abbildung 126. Installing system board
Nächste Schritte
1. Replace the following:
a. Trusted platform module
b. Internal PERC card
c. Optional internal USB memory key
d. IDSDM/vFlash module card
e. All expansion cards and risers
f. Processors and heat sink modules
g. Processors blanks (if applicable)
h. Memory modules and memory module blanks
i. LOM riser card
j. Drive cage (rear) (if applicable)
k. Air shroud
2. Reconnect all cables to the system board.
ANMERKUNG: Ensure that the cables inside the system are routed along the chassis wall and secured using the
cable securing bracket.
3. Install the system cover.
4. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
5. Open the drive bays, install
6. Install the power supply
7. Follow the procedure listed in
8. Ensure that you:
all drives, and then close the drive bays.
units.
After working inside your system.
Installing and removing system components
www.dell.com/
143