Removing The Microsd Card - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 109. Installing optional IDSDM/vFlash card
Nächste Schritte
1. Install the MicroSD cards.
ANMERKUNG: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards
during removal.
2. Install the air shroud.
3. Install the system cover.
4. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
5. Open the drive bays, install
6. Install the power supply
7. Follow the procedure listed in

Removing the MicroSD card

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7. Remove the system cover.
8. Remove the air shroud.
9. Remove the IDSDM or vFlash module.
Schritte
1. Locate the MicroSD card slot on the IDSDM/vFlash module, and press the card to partially release it from the slot.
2. Hold the MicroSD card and remove it from the slot.
ANMERKUNG: Temporarily label each MicroSD card with its corresponding slot number after removal.
all drives, and then close the drive bays.
units.
After working inside your
Safety Instructions.
all drives, and then close the drive bays.
units.
system.
Installing and removing system components
www.dell.com/
127