M.2 Ssd Module; Removing The M.2 Ssd Module - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 105. Installing butterfly riser
Nächste Schritte
1. If removed, install the rear drive cage.
2. Install the air shroud.
3. Install the system cover.
4. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
5. Open the drive bays, install
6. Install the power supply
7. Install any device drivers required for the card as described in the documentation for the card.
8. Follow the procedure listed in

M.2 SSD module

Removing the M.2 SSD module

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7. Remove the system cover.
8. Remove the air shroud.
9. If installed, remove the rear drive
10. Remove the BOSS card.
all drives, and then close the drive bays.
units.
After working inside your
Safety instructions.
all drives, and then close the drive bays.
units.
cage.
system.
Installing and removing system components
www.dell.com/
123