Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch Seite 100

5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7. Remove the system cover.
8. Remove the air shroud.
9. If installed, remove the rear drive
10. If installed, remove the
11. Remove a processor and heat sink
Schritte
1. Place the heat sink with the processor side facing up.
2. Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
grease seal.
3. Push the retaining clips on the processor bracket to release the bracket from the heat sink.
Abbildung 76. Loosening the processor bracket
4. Lift the processor bracket away from the heat sink, and place the processor connector side down on the processor tray.
5. Flex the outer edges of the bracket to release the bracket from the processor.
ANMERKUNG: Ensure that the processor bracket is placed in the tray after you remove it from the heat sink.
100 Installing and removing system components
units.
cage.
risers.
module.