Installing A Processor And Heat Sink Module - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

• Ensure that the pin 1 indicator on the heat sink is aligned with the pin 1 indicator on the bracket before placing
the heat sink onto the processor bracket.
Abbildung 80. Installing the heat sink onto the processor
Nächste Schritte
1. Install the processor and heatsink.
2. If removed, install the risers.
3. If removed, install the rear drive cage.
4. Install the air shroud.
5. Install the system cover.
6. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
7. Open the drive bays, install
8. Install the power supply
9. Follow the procedure listed in

Installing a processor and heat sink module

Voraussetzungen
VORSICHT: Never remove the heat sink from a processor unless you intend to replace the processor. The heat sink is
necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
all drives, and then close the drive bays.
units.
After working inside your
Safety instructions.
all drives, and then close the drive bays.
system.
Installing and removing system components
www.dell.com/
103