Installing The Microsd Card - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 110. Removing the MicroSD card
Nächste Schritte
Replace the MicrosSD card.

Installing the MicroSD card

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud.
10. Remove the IDSDM or vFlash module.
ANMERKUNG: To use an MicroSD card with your System, ensure that the Internal SD Card Port is enabled in System
Setup.
ANMERKUNG: If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had
marked on the cards during removal.
Schritte
1. Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot.
ANMERKUNG: The slot is designed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
128 Installing and removing system components
Safety Instructions.
all drives, and then close the drive bays.
units.