Adjusting The X-Axis; Adjusting The Y-Axis - Fronius LaserHybrid Bedienungsanleitung

Adjusting the x-
axis
Setting and reading the change of position in the x di-
rection
3
4
5
Adjusting the y-
axis
Setting the change of position in the y direction
Make the desired position adjustment using the adjusting screw, as shown in the fig-
ure
A quarter turn corresponds to an adjustment distance of 0.25 mm.
A full turn corresponds to an adjustment distance of 1 mm.
Adjustment range ... +/- 2 mm
Tighten the fixing screws (2)
(Figure: Fixing screws for the coordinate axes)
Fit the housing cover
x
Remove the housing cover from the
1
LaserHybrid head
Undo the fixing screws (2)
2
(Figure: Fixing screws for the coordina-
te axes)
Reading the change of position in the y direction
71