Parking Brake Lever; Light Switch - EMAK 102-122 Gebrauchsanweisung

On being released at the «START» position, the key will auto-
matically return to «ON».

4.5 PARKING BRAKE LEVER

This lever is to stop the machine from moving when it has been
parked. There are two positions:
«A» = Brake off
«B» = Brake engaged
– The brake is engaged by fully pressing the pedal (4.31) and
moving the lever to position «B». When you take your foot off
the pedal it will be blocked by the lever in the down position.
– A pilot lamp will warn that the brake is engaged (4.10.a).
– To disengage the parking brake, press the pedal (4.31). The
lever will return to position «A».

4.6 LIGHT SWITCH

For turning on the lights when the key (4.4) is in the «ON» posi-
tion.
4.7 BLADE ENGAGEMENT AND BRAKE CONTROL
The mushroom switch (4.7) is for engaging the blades by an
electromagnetic clutch:
EN 14
«A» Pressed = Blades disengaged
«B» Pulled = Blades engaged
– If the blades are engaged when safety conditions have not
been complied with, the engine shuts down and cannot be
restarted ( 5.2).
– The "Blades engaged" condition is indicated by a pilot lamp
(4.10.c).
– On disengaging the blades, a brake is simultaneously activat-
ed which stops their rotation in few seconds.
4.8 CUTTING HEIGHT ADJUSTING LEVER
There are seven positions for this lever, shown as «1» to «7» on
the label, which correspond to various heights of between 3 and
9 cm.
– To go from one height to another, press the release button at
the end of the lever.
4.9 CONTROL FOR TIPPING GRASS-CATCHER
Manual tipping
The grass-catcher may be tipped to
empty by pulling the lever (4.9.1),
which can be extracted from its hous-
ing.
4.9.1