Abus Terxon MX Installationsanleitung Seite 179

118 RemoteTel No 1
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 118:DL Tel No 1
3. Via the keypad, enter the telephone number.
A
Use key to enter a 4-second pause (shown by
a comma).
u
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
119 RemoteTel No 2
See command 118.
120 RemoteTel No 3
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 120:DL No 3=OFF
3. Via the keypad, select from the following items
and press:
DL No 3=OFF
0
The alarm centre does not just accept
any remote telephone number.
DL No 3=ON
The alarm centre accepts any numbers
from remote PCs. The remote PC
1
transmits its number to the alarm centre
and the alarm centre uses this number
for the call back.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer mode.
118
120
75
123 Reset report
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 123:Restore OFF
3. Via the keypad, select from the following items
and press:
Restore OFF
0
The alarm centre does not
communicate any resets.
Restore ON
The alarm centre communicates resets.
1
(Function only with Scancom Fast
Format)
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
124 Switch open/close
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 124:Rev O/C OFF
3. Via the keypad, select from the following items
and press:
Rev O/C OFF
0
Open/Close not switched
Rev O/C ON
1
The function switches the commands
Open/Close for Scancom Fast Format.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
123
124
UK