eta 90064 Bedienungsanleitung Seite 94

– We recommend holding (supporting) the outgoing dough in the desired shape to
prevent tearing.
– Small amount of unprocessed dough will always remain in the mincer body.
Therefore we recommend processing larger volumes (at least 300 g).
– To have the dough compact, you must continuously feed the dough in the mincer in
sufficient amount.
– Best results in feeding any dough are achieved when you shape the dough into a roll
with the diameter smaller than the hopper opening, and put it directly into the hopper.
III.4) Grating disc adapter (M)
Description
M0 – Adapter body
M1 – Motor shaft + ejector
M2 – Lid
M3 – Hopper
M4 – Cover / guiding piece
M5 – Pusher
N – Gearbox – IMPORTANT: (The grating adapter with disc graters can only be put in
– Never push down the grated/sliced fruits or vegetables by fingers! Move the food along
the feed tube by the pusher, slowly, while pushing down slightly.
– Be careful when handling the graters. They employ very sharp blades.
– Never use the graters to process hard materials, for example ice cubes, coffee / cereal
/corn grains, spices, etc.
– When processing a large amount of food, check if the food is not cumulating above and
below the grater.
– If the grating adapter is blocked, switch off the motor unit, disassemble the adapter
body and clean it.
– Never remove the lid M2 when the motor is running!
Assembly
Assemble the grating adapter M according to Figure 8. Then attach the gearbox N to
the motor unit head, and put the assembled adapter M on it according to Figure 7. Apply
reverse procedure to disassemble the unit and to remove it from the motor unit head.
Preparing the food
The attachments can be used for chopping, slicing, grating and scraping of almost any type
of fruits or vegetables. You can slice carrots, potatoes, cabbages, cucumbers, zucchinis,
beetroots, mushrooms, onions, etc. You can use the slicing/chopping grater to process
fruits, vegetables, cheese and food of similar structure. The cheese greater is designed for
processing hard cheeses and making bread crumps.
Tipy
M6 – Thin slicing grater
M7 – Thick slicing grater
M8 – Fine grater
M9 – Coarse grater
M10 – Cheese grater
M11 – Coarse very grater
M12 – Protective sleeve to store graters
operation with a gearbox mounted)
Safety hints and tips
94 / 234
EN