eta 90064 Bedienungsanleitung Seite 118

EN
8) Citrus press O
Immediately after use, wash the attachments in hot water with a detergent and let dry out.
Proceed carefully not to damage the sieve.
9) Blender F
Immediately after use, wash the attachments in hot water with a detergent and let dry out.
Knife cleaning procedure: pour about 0.5 l of clear water in the container, switch on the
appliance and remove the impurities by several pulses. In the case of larger amount of
impurities, repeat the procedure several times, or pour 1 litre of water, add a small amount
of detergent and switch on the blender for 1 minute. For easier cleaning, take the knife F3
from the blender base F2 according to Fig. 18. To release the knife F3, use the release key F8.
Sealing replacement procedure
Proceed according to Fig. 11 and 18. If the sealings F4 is worn or damaged, replace it with
a new one (of identical type ETA 012800400).
10) Pasta makers G
Wipe the pasta adapters with a damp cloth after use. Do not immerse into water – avoid
water getting in the internal components!
11) Pasta formers I
Immediately after use, wash the formers in hot water with a detergent and let dry out.
If necessary, you can wash them in a dishwasher, or you can easily clean them with
a suitable fine brush.
12) Grein mill for Cereals, Legumes and Rice Q
Clean the body of the grinder Q0 with a clean wet cloth. Plastic parts (i.e. hopper Q6) may
be washed in the dishwasher.
Never soak grinding stones Q2, Q4 in water and never use
a wet brush to clean their surface! Also, do not use any steel or
other metal brushers, steel wool etc. to clean the stones!
Avoid getting the grinding edges / grooves in contact with hard items, which would
blunt them and thereby reduce their effectiveness.
Any impurities in gaps or corners and grinding stones may be easily cleaned with the
provided brush Q10. When cleaning the grinding stones, be very careful! Make sure that
the grinding edges / grooves of the stones do not come in contact with hard objects that
dull them and thus reduce their efficiency.
Procedure for replacing stones (Fig. 17)
When the grinding stones are damaged or worn out too much, it is necessary to purchase
new ones and replace them. Disassemble the grinder. Using a suitable tool (such as
a screwdriver), release the cover Q1 by gradually inserting a screwdriver into the 4 pcs
screws Q8 unscrew from the body Q0 of the grinder. You can now easily remove the
cover Q1. Remove (knock out) the fixed grinding stone Q2 from the body of the grinder
Q0. Replace the stone with a new one (the same type ETA 0028000960). Them and thus
reduce their efficiency.
Attention: Make sure that the cut created in the grinding stone precisely "fits" the
created protrusion on the body of the grinder.
118 / 234