Faller 163701 Bedienungsanleitung Seite 112

Converting the vehicle
To make a seat receiving the ultrasonic capsule, bore a hole of 10 mm
X
diameter at most, through the trunk. You will ideally use a pillar dril-
ling machine with sheet metal rough-turning drill or twist drill. Alter-
natively you can also manufacture such bore using a standard drill, a
rod-shaped mortiser or a battery powered screw driver.
NOTE: The diameter of the ultrasonic capsule is 10 mm. It might be use-
ful to approach that size by drilling several holes that are slightly smaller.
EN
Fig. 37: Bore in the vehicle body
Use a modeller's knife, a file or a rod-shaped mortiser to retouch or,
X
if necessary, to enlarge the bore you have made through the vehicle
roof, until the exact diameter required for receiving the ultrasonic cap-
sule is reached.
Fig. 38: Retouching the bore through the vehicle body
Secure the positioning ring intended to receive the ultrasonic capsule,
X
in the vehicle roof, using some instant adhesive.
Secure the ultrasonic capsule in the positioning ring with a minute
X
quantity of viscous instant adhesive gel.
NOTE: When securing the capsule, care should be taken that no adhesive
flows into the interior of the capsule.
112