Faller 163701 Bedienungsanleitung Seite 104

Converting the vehicle
NOTE:
Using a side cutter remove the resistor installed.
X
Heat the soldering iron.
X
Detach both outgoing cables of the motor. Leave unchanged both
X
cables on the side that leads in the motor.
Detach all other wirings from components (charging socket, switch,
X
dry-reed sensor, rechargeable batteries).
EN
Fig. 21: Lorry model, without wiring
Type: Lorry model with universal PCB, soldered batteries
RECOMMENDATION: Do not remove the green universal PCB that is firmly in
place, to carry out the conversion, but permanently leave it within the vehicle.
Fig. 22: Lorry model, soldered batteries, top view
104