Ramp Times For Setpoint Change; Automatic Pwm Frequency Reduction; Diagnostics And Measured Values - Wilo Yonos GIGA2.0-I Einbau- Und Betriebsanleitung

14.2

Ramp times for setpoint change

Ramp times
Ramp times:
Start-up time
Ramp times:
Switch-off period
Fig. 86: Ramp times menu
14.3 Automatic PWM frequency reduc-
tion
Automatic PWM
frequency reduction
Switched off
Switched on
Fig. 87: PWM frequency reduction menu
15 Diagnostics and measured val-
ues
Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.01/2023-03
NOTICE
If a mains disconnection is planned for a longer period of time, the pump
kick must be taken over by an external control by briefly switching on the
mains voltage.
For this purpose, the pump must be switched on at the control side before
the mains disconnection.
The ramp times of the pumps can be set in the menu
Universal
1.0
1.6
1.6.2
1.6.2.1
1.6.2.2
The ramp times define the maximum speed at which the pump may ramp up and down when
the setpoint is changed.
The adjustable value range for ramping up and down is between 0 s and 180 s. For the fact-
ory setting, see "Factory setting" [" 198] section.
The function "Automatic PWM frequency reduction" can be switched on and off in the
menu "Settings", "Additional settings":
Universal
1.0
1.6
1.6.4
OFF
ON
The function is available depending on type.
The "Automatic PWM frequency reduction" function is switched off in the factory.
If the ambient temperature of the pump is too high, the pump independently reduces the
hydraulic output.
If the "Automatic PWM frequency reduction" function is activated, the switching frequency
changes from a critical temperature in order to continue supplying the required hydraulic op-
erating point.
NOTICE
A changed switching frequency can lead to higher and/or changed operat-
ing noises of the pump.
In order to support fault analysis, the pump provides additional help apart from fault noti-
fications:
Diagnostics help is used for diagnosis and maintenance of electronics and interfaces. In ad-
dition to hydraulic and electrical overviews, information on interfaces and unit information
is displayed.
The following table provides an overview of the menu
ues":
Display text
Settings
Additional settings
Ramp times
Ramp times: Start-up time
Ramp times: Switch-off period
Display text
Settings
Additional settings
Automatic PWM
frequency reduction
Switched off
Switched on
"Settings", "Additional settings".
"Diagnosis and measured val-
en
191