Error Messages And Troubleshooting - Varex Imaging XRpad2 HWC-M Digital X-ray Bedienungsanleitung

XRpad2 HWC-M Detectors User Manual
Wipe the entire surface of the target areas of the system until they are visibly wet with the
4
chemical solution. Target areas include any surface that was cleaned and/or any other
surfaces potentially contaminated during system use without visible soil.
Take care to wet seams, joints, and other difficult-to-reach areas.
5
Ensure that the surfaces remain visibly wet for the maximum necessary disinfection time
6
specified on the product label.
If a disinfection time is not specified on chemical label for the concentration used, ensure
a
that the surfaces remain visibly wet for a minimum of 10 minutes.
Use additional fresh wipes as needed to ensure continuous wet contact time during the
b
specified disinfection period.
Let air dry.
i
If visible residue is evident after air drying, remove residue with a general isopropyl
ii
alcohol wipe, and let air dry.
Do not reuse wipes. Discard wipes and gloves into clinical waste.
iii
19.6

Error Messages and Troubleshooting

If any error messages appear, follow the instructions in the Digital Radiography Software Manual.
If there is any problem that is not described in the manual, immediately ask your establishment's
safety representative to contact your dealer, distributor, or device manufacturer. Further use
may result in severe personal injury, death, or substantial product damage.
WARNING
If any abnormal condition, such as smoke, fumes, or strange sounds, is
evident, turn off the X-ray detector, turn off and unplug the power
supply from the AC outlet, and immediately ask your establishment's
safety representative to contact your dealer, distributor, or device
manufacturer.
Further use under abnormal conditions may result in severe personal
injury, death, or substantial product damage.
www.vareximaging.com
Inspection and Maintenance
67