• P P o o w w e e r r - - L L O O A A D D operates at 13.56 MHz when you use P P o o w w e e r r - - L L O O A A D D controls with a powered cot (P P o o w w e e r r - - P P R R O O XT or

P P o o w w e e r r - - P P R R O O IT) that could interfere with other equipment that operate at this frequency band.

• Do not use accessories, transducers, and cables, other than those specified, with the exception of transducers and

cables that are sold by Stryker as replacement parts for internal components, to avoid potentially increased emissions or

decreased immunity of the P P o o w w e e r r - - L L O O A A D D system.

• Do not use the P P o o w w e e r r - - L L O O A A D D system and the P P o o w w e e r r - - P P R R O O cot adjacent to or stacked with other equipment. If adjacent

or stacked use is necessary, observe the P P o o w w e e r r - - L L O O A A D D system to confirm normal operation in the configuration where it

will be used.

• P P o o w w e e r r - - L L O O A A D D operates primarily at these frequencies: 70 - 85 kHz for inductive charging and 13.56 MHz±7 kHz,

Amplitude Modulated (OOK), ERP: -82.37 dBm. The inductive charging can operate between these frequencies: 70 -

125 kHz. Other equipment may interfere with the P P o o w w e e r r - - L L O O A A D D system, even if that other equipment complies with

CISPR emission requirements.

C C A A U U T T I I O O N N

• This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at their expense. In the event of interference, please relocate or

reorient the P P o o w w e e r r - - L L O O A A D D system or interfering product.

• Always relocate or reorient the P P o o w w e e r r - - L L O O A A D D system or interfering product in the event of interference. This device

complies with Part 18 of the FCC Rules.

• Do not use portable RF communications equipment (including peripherals such as antenna cables and external

antennas) closer than 30 cm (12 in.) to any part of the P P o o w w e e r r - - L L O O A A D D system, including cables specified by the

manufacturer. Otherwise, degradation of the performance of this equipment may result.

• The emissions characteristics of this equipment make it suitable for use in industrial areas and hospitals (CISPR 11

class A). This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area (for which CISPR 11 class B is normally required) is likely to cause harmful interference,

in which case the user will be required to correct the interference at their expense. In the event of interference, please

relocate or reorient the P P o o w w e e r r - - L L O O A A D D system or interfering product.

G G u u i i d d a a n n c c e e a a n n d d m m a a n n u u f f a a c c t t u u r r e e r r ' ' s s d d e e c c l l a a r r a a t t i i o o n n - - e e l l e e c c t t r r o o m m a a g g n n e e t t i i c c e e m m i i s s s s i i o o n n s s

P P o o w w e e r r - - L L O O A A D D is intended for use in the electromagnetic environment specified below. The customer or the user of

P P o o w w e e r r - - L L O O A A D D should assure that it is used in such an environment.

E E m m i i s s s s i i o o n n s s t t e e s s t t

RF Emissions

CISPR 11

RF Emissions

CISPR 11

RF Emissions

CISPR 11

C C o o m m p p l l i i a a n n c c e e

Group 1

Group 2