HBM WE2108 Serie Referenzhandbuch Seite 96

96
Procedure:
5. Entry of the data of the calibration site with LGC1 / LGC2
6. Calibration with calibration weight, LDW, LWT
7. Entry of the data of the installation site with LGC1 / LGC2
8. TDD1
c) Calibration with linearization, then transport to the installation site
Procedure:
6. Entry of the data of the calibration site with LGC1 / LGC2
7. Provisional calibration with weights, LDW, LWT. This is required for activating the geo-
8. Calibrate scale at all weight values (3 or 4), (entry with LVA or weight calibration with
9. Entry of the data of the installation site with LGC1 / LGC2
10. TDD1
d) With mV/V calibration (at the installation site or at the manufacturer)
Procedure:
6. Resetting the geographical correction with LGC0. In this way the values for Darmstadt
7. Measuring the bias load, entry with LVA1;
8. Calculating the span and entry of the internal value LVA3. Refer to Section 5.4.1 of the
9. Entry of the data of the installation site with LGC1 / LGC2
10. TDD1;
In this method only the span is corrected. A slight error arises for the zero point at the new
installation site, which can be compensated for by the switch−on zero function ("Auto_Z").
HBM
What is described by the characteristic
parameters (LVA..)?
Internally stored gravitation
Meaning of LGC1 / LGC2
graphical correction. The accurate weight value is not relevant here.
menu)
What is described by the characteristic
parameters (LVA..)?
Internally stored gravitation
Meaning of LGC1 / LGC2
are set, which are also the basis for calibration of the load cells.
Operating Manual.
Relationship of measured values and display at the calibration site
Gravitation of the calibration site
Geographical data of the installation site
Relationship of measured values and display at the place for which
the load cell characteristic applies
Gravitation of the place for which the load cell characteristic applies
(for HBM load cells: Darmstadt)
Geographical data of the installation site
Scale electronic unit (NSW)
WE2108