Using The Automatic Wheel Clamping System C - Corghi EM9980 TouchlessLine Betriebsanleitung

USING THE AUTOMATIC
WHEEL CLAMPING
SYSTEM C
NOTE:
After every power on, the first time the automatic
wheel clamping system is activated using the
pedal, the machine will perform a calibration by
automatically moving the two ratchets located on
the hub towards the outer side. When calibration
is complete, the operator can use the machine
as described below.
Wheel locking procedure with the automatic C:
Centring with cone at front
- Fit the wheel on the shaft, sliding it into place
until it rests against the flange.
- Fit the most suitable cone on the shaft and
insert it into the central hole of the wheel.
- Fit the locking device by making it slide on
the hub until it comes into contact with the
cone.
- Press the control pedal for at least one second.
Centring with cone at rear
- Fit the most suitable cone for the central hole
of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into
place until the cone comes into contact with
the plate that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on
the hub until it comes into contact with the
wheel.
- Press the control pedal for at least one second.
Wheel release
- Press the control pedal for at least one second
to release the wheel from the flange.
Centring with flanges
C hub removal
- Keep the Stop button
keypad pressed for at least 3 seconds to
lock the wheel-holder shaft and the internal
devices.
- Insert the C special key provided with the
machine in the C hub hole (Fig. 12).
EM9980 TouchlessLine - Operator's manual
- Unscrew the C hub completely.
- Mount the flange on the shaft and lock it with the
two screws (A, Fig. 13) using the CH 6 wrench.
A
- Lock the wheel onto the flange as usual.
IMPORTANT
To work without the hub removed previously the
machine must be set in flange mode as described
in the "CONFIGURATION PROGRAMMES"
section.
C hub mounting
Proceed as follows to remount the C hub:
- Go to the utility and configuration programmes
on the
and press the
wheel-holder shaft and the internal devices.
- Screw the C hub manually until it reaches the
end position.
- Tighten the C hub by inserting the C special
wrench into the C hub hole (Fig. 14).
12
13
UK
icon to block the
55