Corghi EM9980 TouchlessLine Betriebsanleitung Seite 66

-
the radial run-out of the tyre peak-to-peak;
- the wave forms show the progress of the wheel
runout.
If a rim is mounted, the following icons are
displayed at the end of the spin indicating:
-
the radial run-out of the inner tyre bead (1
harmonic);
-
the radial run-out of the inner tyre bead
(peak-peak);
-
the radial run-out of the outer tyre bead (1
harmonic);
-
the radial run-out of the outer tyre bead
(peak-peak);
66
-
the lateral run-out of the rim (1
-
the lateral run-out of the rim (peak-to-peak).
Note: The vertical mobile bar that appears in
the graphs shows the vertical axis at 12 o'clock.
IMPORTANT: If present, all the adhesive
weights fixed to the inner surface of the rim
st
and arranged along the laser sensor scanning
area must be removed before determining
the runout measurement cycle.
If a wheel assembly is mounted where geometric
deformation has been found in both the rim and
tyre, the effects of this on the wheel assembly may
be minimised by compensating the deformation
of the rim with the deformation of the tyre.
Notification of Geometric matching is given with
an end of measurement cycle message with one
of the following indications:
- Matching not recommended
- Matching recommended
If you want to perform Geometric matching,
select the ROD Matching icon
- bring the valve to the 12 o'clock position and
st
press the
monitor;
- Turn the wheel until the machine indicates
where to stop.
- use chalk to make a mark on the tyre at the
12 o'clock position, then press the
EM9980 TouchlessLine - Operator's manual
st harmonic);
or button on the
.