Maintenance Schedule - probst SH-3500-B Betriebsanleitung

MAINTENANCE

Maintenance schedule

The below-mentioned intervals should be reduced during heavy use.
Interval
Initial inspection after
25 hours of use
Every 50 hours of use
Remaining components
The yearly inspection must be performed by a qualified specialist (see chapter 0).
Inspect safety features
(see chapter 9.7)
•
Vacuum gauge
•
Check that warning light flashes at correct
underpressure/overpressure values
•
Visual inspection of load securing chain 1)
Inspect vacuum filter and replace if necessary
Gasoline motor (see also separate operating instructions)
Inspect V-belt, replace if necessary
Replace V-belt
Check oil fill level (oil dipstick)
Change oil
Inspect air filter
Replace air filter (more frequently in dusty
environments)
Inspect spark plug
Replace spark plug
Vacuum pump (see also separate operating instructions)
Check oil fill level (level indicator)
Check filter resistance gauge (28) – if it indicates a
value in the red range, replace oil trap
Replace oil trap
Replace the oil and oil filter every 500 to 2000
operating hours and at least every 6 months (oil
quantity 1.5 l, oil type: see separate operating and
maintenance instructions for the vacuum pump)
Are the vacuum hoses in good condition (not brittle, not
kinked, no worn sections and no leaks)?
54
Work to be completed
Check and tighten all fastening screws (this may only be carried out by a specialist).
Tighten all fastening screws (make sure the screws are tightened according to the
given tightening torque values of the associated strength grades).
Check that all joints, guides, bolts and gear wheels (if present) are functioning
properly. Adjust or replace as needed.
:
Interval
Daily Weekly Monthly Every
X
X
X
X
X
X
X
X
Yearly
six
months
X
X
X
X
X
X
X
X
X
X