Load Characteristics - probst SH-3500-B Betriebsanleitung

OPERATION
The radio remote control has been tested and complies with the statutory limits for a Class B digital device
according to Part 15 of the FCC Regulations. These limits are intended to protect against harmful
interference in residential areas.
The radio remote control produces, uses and emits high frequencies that may disrupt radio traffic if it is not
used in accordance with these instructions.
However, there is no guarantee that interference will not occur in a particular installation. If the radio
remote control causes radio or TV reception interference that
can be determined by turning the device off and on, it is recommended to eliminate the interference using
one or more of the following measures:
•
Increase the distance between radio remote control and receiver.
•
Consult a dealer or experienced radio/TV specialist.
WARNING

Load characteristics

WARNING
34
•
For retrofitting the radio remote control (retrofitting kit), see the separate
installation instructions.
•
For notes on operation and maintenance of the radio remote control, see
the original manufacturer's installation instructions for the radio remote
control "Tele Radio Panther".
During operation using radio remote control:
Risk of injury from uncontrolled movement of the lifting device
►
Always keep an eye on the transport path and load.
►
Only work when you have a good view of the entire working area.
►
Ensure that no one is within the danger zone before releasing the load.
Risk of injury from falling parts
►
It is not permitted to pick up loads with moist, wet, oily, icy, dirty or dusty surfaces,
or with any other surface characteristics that might reduce the friction.
►
It is not permitted to operate the device in moist, wet, oily, icy, dirty or dusty
environments, or in any other environments that might reduce the friction.
►
The maximum lift capacity of the individual suction plates must not be exceeded.