Changing The Suction Plate; Use Of The Spreader Bar With 2 Suction Plates - probst SH-3500-B Betriebsanleitung

START OF OPERATIONS
CAUTION
Installation of the lifting device is complete after at least three to four successful
test runs with a load. A type test covers the inspections required in Europe before
initial use in accordance with DIN EN 13155.

Changing the suction plate

1. Set the lifting device down on its parking feet (see chapter 7.1).
2. Turn the lifting device off.
3. Detach the vacuum hose.
4. Secure the suction plate from falling.
5. Release the socket pin attachment.
6. Pull out both socket pins.
7. Lift the lifting device while keeping the suction plate steady.
8. Attach the new suction plate to the lifting device (see chapter 5.3).
9. Store unused suction plate in a suitable location (see chapter 1).
Use of the spreader bar with 2 (3) suction plates
When using the spreader bar with 2 suction plates only suction plates of the same design (carrying
!
capacity, dimensions and form) may be used!
The suction plates must always have the same distance (A) to the vertical centre axis of the spreader bar
(see figure 1).
Unequal positioning of the suction plates is not permitted (see figure 2)!
Take care that the load (stone slab) hangs always horizontal.
Vacuum-
device
A
Figure 1
28
Risk of injury due to heavy suction plate
►
Always use appropriate lifting and transport equipment when handling the suction
plate.
Spreader bar
A
Suction plate
B
Figure 2
A