SATA AE1031H Bedienungsanleitung Seite 114

screws and washers (Fig. 5d and 5e)
.Connect the machine to the power supply and the
compressed air supply.
.Remove the lifting hook from the tyre changer
3.2. INSTALLATION
The machine must be installed in accordance with all applicable safety regulations, including but not limited to those
issued by OSHA.
Risk of Explosion or Fire. Never use the machine in an area where it will be exposed to flammable vapours (gasoline,
paint thinners solvents, etc.). Never install the machine in a recessed area or below floor level.
IMPORTANT: for the correct and safe operation of the machine, the
lighting level in the place of use should be at least 300 lux.
Install the tyre changer in the chosen location, com.plying with the
minimum clearances shown in fig. 6. The support surface must have
a load-bearing capac.ity of at least 1000 kg/m2.
Ambient conditions
in the place of operation
.Relative humidity 30% ÷ 95% without condensation.
.Temperature 0°C ÷ 50°C.
114
AE1031H
中文
EN
CAUTION!
DE RU KO PT JA ES