ECOLAB Versatronic Betriebsanleitung Seite 473

PC setup program
Settings
setting point
Unit:
IP address / hostname
Check host name and convert View by pressing the button
Unit:
Port number / port name
Extended
After clicking "Next", the assistant opens the next setup dialogue.
Setup dialogue - Summary of Settings
To complete the configuration, the user gets an overview of the settings. If the connection
default "USB connection" is selected, this overview will appear right after dialogue "Device
login" because no settings are required for the USB connection normally or only one
device of the same type is connected. See Fig. 107.
An erroneous setting can be corrected by the user calling up the right setup dialogue
again by clicking the "Back" and then making the correction. After clicking on "Finish" the
assistant is finished and the new connection in the device connection list is registered.
Fig. 107: Setup dialogue - Summary of Settings
417102269 Rev. 2-08.2020
Selection / option
Enter the IP address or name.
Or click on the "Search"
button and select the device
from the list by double-
clicking.
The port number or the port
name can be changed only in
the advanced settings (see
below).
Call by pressing the button
202
Explanation
The IP address or host name of the device is
a function which finds all available ones on
the local network device and displays them on
a list.
Button to change the host name to the IP
address of the device. If applicable, the
screen shows all host names registered to an
address as well as alternate addresses .
Port number or port name of the device
Default port: 80
Advanced settings for communication
These settings should be changed only in
exceptional cases.