Hyperdeck Control; Introducing Hyperdeck Control - Blackmagic Design ATEM Live Installations- Und Bedienungsanleitung

HyperDeck Control

Introducing HyperDeck Control

If you are running ATEM Switchers software 6.8 or newer, you can connect up to 4 Blackmagic
HyperDeck Studio disk recorders to your switcher and control them using the HyperDecks
palette in ATEM Software Control, or from the system control buttons on an ATEM advanced
panel. This is a very powerful feature! With four HyperDecks connected to your switcher, it's like
having a portable videotape department able to record outputs from your switcher, play back
graphics, or you can even set your switcher to roll prerecorded segments at the press
of a button!
Transport controls are located in the HyperDecks palette in ATEM Software Control, or in the
system control menu on an ATEM advanced panel, which lets you play back video, jog and
shuttle, skip clips, pause and more. You can also record video.
When you combine this feature with ATEM's powerful macros feature, it opens up a world of
creative possibilities that can really enhance your live production!
HyperDeck Extreme 8K HDR and HyperDeck Extreme Control
Connecting HyperDecks
Connecting Blackmagic HyperDecks to your switcher is very similar to connecting cameras and
other video sources via your switcher's SDI or HDMI inputs. The only additional connection is
Ethernet which lets your ATEM switcher communicate with the HyperDeck disk recorder.
1 Using the Ethernet connector, connect your HyperDeck disk recorder to the same
network your ATEM switcher is connected to.
2 Press the remote button marked 'REM' on the HyperDeck's control panel. The 'REM'
button will illuminate which means the HyperDeck has remote control enabled.
If you are using a HyperDeck Studio Mini, turn remote on via the settings tab on
the LCD menu.
3 Plug the SDI or HDMI output of your HyperDeck into the SDI inputs of your
ATEM switcher, or the HDMI inputs if available. If you are using quad link SDI,
it's important to connect each input and output in the correct order.
4 If you want to record your ATEM switcher's program output with your HyperDeck,
plug one of the switcher's SDI auxiliary outputs into the SDI input of your HyperDeck.
With ATEM Constellation 8K, you can connect any SDI output to the SDI input of your
HyperDeck.
5 Repeat the process for each HyperDeck you want to connect.
HyperDeck Control 84