Blackmagic Design ATEM Live Installations- Und Bedienungsanleitung Seite 174

Color Balance Controls
The red, green and blue color balance knobs in the panel's mid section are for adjusting the
color balance of the lift, gamma and gain levels. The white controls are for adjusting the RGB
values for the gain, or highlights and the black controls are for adjusting RGB values of the lift,
or the shadows. The black/flare button lets you adjust the RGB values for the gamma, or mid
tones, by holding down the button and adjusting the lift RGB knobs.
The color balance controls let you make fine adjustments to the red, green, blue
channels for the master gain/white, gamma and pedestal/black levels
There is also a custom control that will be uniquely assignable in a future update. Currently, the
custom control knob is set to Y gain control. This increases or decreases the overall luminance,
or brightness, of the image. More information about color balance control is provided in the
following 'controlling cameras' section.
Lens Controls
The lower section of the panel is where most of the control will occur during production.
The first item you will probably notice is the joystick control. This is used to open and close the
iris, also known as the white level or gain control and for adjusting the master black level, also
known as the pedestal control.
TIP You can also press the joystick down to switch its camera to the auxiliary preview
for camera control.
Gain is adjusted by leaning the joystick forwards or backwards to open or close the iris.
Increase or decrease the pedestal by rotating the ring wheel underneath the joystick's knob
clockwise or counter clockwise. This gives you fine control over both parameters using the
same controller.
Using ATEM Camera Control Panel 174